Marisa Di Sabatino
Marisa Di Sabatino
Verified email at
Cited by
Cited by
Degassing, hydrogen and porosity phenomena in A356
D Dispinar, S Akhtar, A Nordmark, M Di Sabatino, L Arnberg
Materials Science and Engineering: A 527 (16-17), 3719-3725, 2010
Light-induced boron-oxygen defect generation in compensated p-type Czochralski silicon
D Macdonald, F Rougieux, A Cuevas, B Lim, J Schmidt, M Di Sabatino, ...
Journal of applied physics 105 (9), 2009
In situ investigation of spinodal decomposition in hypermonotectic Al–Bi and Al–Bi–Zn alloys
PL Schaffer, RH Mathiesen, L Arnberg, M Di Sabatino, A Snigirev
New Journal of Physics 10 (5), 053001, 2008
Electrical fragmentation as a novel route for the refinement of quartz raw materials for trace mineral impurities
E Dal Martello, S Bernardis, RB Larsen, G Tranell, M Di Sabatino, ...
Powder technology 224, 209-216, 2012
A review on the fluidity of Al based alloys
M Di Sabatino, L Arnberg
Metallurgical Science and Tecnology 22 (1), 2004
Distribution of iron in multicrystalline silicon ingots
R Kvande, LJ Geerligs, G Coletti, L Arnberg, M Di Sabatino, EJ Øvrelid, ...
Journal of applied physics 104 (6), 2008
Castability of aluminium alloys
M Di Sabatino, L Arnberg
Transactions of The Indian Institute of Metals 62, 321-325, 2009
Determination of relative sensitivity factors for trace element analysis of solar cell silicon by fast-flow glow discharge mass spectrometry
M Di Sabatino, AL Dons, J Hinrichs, L Arnberg
Spectrochimica Acta Part B: Atomic Spectroscopy 66 (2), 144-148, 2011
Fluidity of aluminium foundry alloys
M Di Sabatino
Fakultet for naturvitenskap og teknologi, 2005
An improved method for fluidity measurement by gravity casting of spirals in sand moulds
M Di Sabatino, F Syvertsen, L Arnberg, A Nordmark
International Journal of Cast Metals Research 18 (1), 59-62, 2005
Surface Passivation Properties of Thin Film on n-Type Crystalline Si
X Cheng, P Repo, H Halvard, AP Perros, ES Marstein, M Di Sabatino, ...
IEEE journal of photovoltaics 7 (2), 479-485, 2017
Recombination activity of grain boundaries in high-performance multicrystalline Si during solar cell processing
K Adamczyk, R Søndenå, G Stokkan, E Looney, M Jensen, B Lai, M Rinio, ...
Journal of applied physics 123 (5), 2018
State-of-the-art growth of silicon for PV applications
L Arnberg, M Di Sabatino, EJ Øvrelid
Journal of crystal growth 360, 56-60, 2012
The influence of oxide inclusions on the fluidity of Al–7 wt.% Si alloy
M Di Sabatino, L Arnberg, S Rørvik, A Prestmo
Materials Science and Engineering: A 413, 272-276, 2005
Oxygen distribution on a multicrystalline silicon ingot grown from upgraded metallurgical silicon
M Di Sabatino, S Binetti, J Libal, M Acciarri, H Nordmark, EJ Øvrelid
Solar energy materials and solar cells 95 (2), 529-533, 2011
Study of defects and impurities in multicrystalline silicon grown from metallurgical silicon feedstock
S Binetti, J Libal, M Acciarri, M Di Sabatino, H Nordmark, EJ Øvrelid, ...
Materials Science and Engineering: B 159, 274-277, 2009
The influence of oxide inclusions on the fluidity of Al-7 wt.% Si alloy
MD Sabatino, L Arnberg, S Rorvik, A Prestmo
Materials Science and Engineering A 413, 272-276, 2005
Detection limits for glow discharge mass spectrometry (GDMS) analyses of impurities in solar cell silicon
M Di Sabatino
Measurement 50, 135-140, 2014
Effect of hydrogen content, melt cleanliness and solidification conditions on tensile properties of A356 alloy
S Akhtar, D Dispinar, L Arnberg, M Di Sabatino
International Journal of Cast Metals Research 22 (1-4), 22-25, 2009
Effect of thermal exposure on the residual hardness and tensile properties of the EN AW-2618A piston alloy
L Ceschini, A Morri, A Morri, M Di Sabatino
Materials Science and Engineering: A 639, 288-297, 2015
The system can't perform the operation now. Try again later.
Articles 1–20